Adaprox Fingerbot ToolPack is an extension kit of Fingerbot. It contains a rocker arm, a ring arm, straight arms with different lengths, two cushion blocks and 3M tapes.
With the modular design, the arm of Fingerbot is replaceable in order to meet different needs in diverse situations. You can install the arm by following the picture below. We provide three straight arms with different lengths to assist Fingerbot better fitting various button-control cases.
Fingerbot makes use of the rocker arm to push and pull the switch button to change the switch status of equipment. Please follow the instructions below to install a rocker arm.
1. After connecting Fingerbot with the App, set Fingerbot to the 'Switch' mode.
2. Move the arm of Fingerbot to the bottom and fix the Fingerbot on the switch panel.
3. Tear off the tape covering on the rocker arm to stick the arm to the switch button.
4. Use the App to adjust the “Up Movement” parameter of Fingerbot's arm, so that its movement range can be adapted to the switch button.
Fingerbot makes use of the ring arm to push and pull a toggle switch to change the switch status of equipment. Please follow the instructions below to install a ring arm.
1. After connecting Fingerbot with the App, set Fingerbot to the 'Switch' mode.
2. Following the picture, fix two cushion blocks to Fingerbot with tape.
3. Put the ring of the arm on the toggle button, and tear off the tape covering on the other side of the cushion block to fix the Fingerbot on the switch panel.
4.Use the App to adjust the movement range of Fingerbot's arm, so that it can be adapted to the toggle.
