MeshHub App is the mobile platform for controlling MeshHub devices. You can search "MeshHub" in the mobile application store to install the App.
Rotate the battery cover anticlockwise to open. Then remove the battery insulation film to power on the product, the red LED will flash slowly for self-checking.
After powered on, the product will enter self-checking state and the red LED will flash for 60s.
Press the reset button for 5 seconds then release, the device is ready to be paired when the signal icon flashes.
Open the App and click the "+" button on the upper right corner, then click the thermometer button in the "Add a device" panel and follow the instructions in the app to pair the device.
After the thermometer is paired, you can long press the device button in the main page of the App to inspect thermometer status and view alarm history.
Installation method 1: Use a 3M sticker to affix the product to the target position.
The automation function is available in the App to connect different devices. Each automation contains a series of trigger conditions and target actions. The target actions will be automatically triggered when the conditions are met.
To set up an automation, click the “+” button in the upper right corner at the automation page. You can use the thermometer as a trigger condition and create target actions with other Adaprox appliances.
